replacing Transmission sensors input/output

[halicat]

I am going on vacation to Newfoundland for a week with the Kat and have purchased the input/output trans sensors in case i have the "stuck in secon gear " problem.
I know that i need a 1" socket to change them over but don't know exactly how to get to them.
If anyone can give me step by step instructions on how to change them it would be greatly appreciated...

Jim

[GT]

Jim--- if you have a fax number I can fax you the pages complete with illustrations from the manual :)
Without the pics, the verbage probably wouldnt do you much good.... let me know? Cell 920 517 6922. or send me a pm. Either way.

[pumpkin]

Jim, go to search on the POA.

[halicat]

Pumpkin.....heres a good one..

the POA site is banned from my work computer...lol

but not Prowltalk...

my fax# is 902-465-2229

The big GT comes through.... thanks friend... :beer:

[pumpkin]

The input sensor is reachable but you need to have the right angled wrench.

The output sensor is a little more forgiving. It is closer to you.

If you stand back and view your CAT from behind, just look to the left of your license plate or drivers side and go underneath. You will see two harness plugs going into your tranny. The input sensor is the one deeper in and the output sensor is the one closer to you.

This may help.

[halicat]

Those are great instructions Norm...

I'll take a peek at it when I get home tonight , Its a rainy day and the Kat has the day off...

Thanks :tu:

[Dreamcast18]

Norm was kind enough the lend us his sensors complete with instructions for our roadtip back to LA. What can I say? He and Pat are the coolest folks in NM!

Jimbo: U've got mail.

[halicat]

What can I say? He and Pat are the coolest folks in NM!



Jimbo: U've got mail.

you got that right..."two flowers in a field of thorns"


I'll check my mail when i get home.... this work computer is pretty restricted....everything is filtered and I cannot access my home e-mail...

but Prowltalk is OK... what can I say, my employer has good taste...

[Dreamcast18]

http://www.prowlerexcitement.com/HeaderFlanges/images/P3143731.jpg

[halicat]

Dreamer does it again !

Thanks For all the help guys....

:tu:

[GT]

I take it you don't want the fax then Jim?

[GT]

On a similar/different subject, I need to replace the oil pressure sending unit/sensor.... I see NOTHING on that one. I got the part, and it's probably a direct replacement, and I "think" it's right around the filter there somewhere... :)
Didnt even see it on Norm's many helpful pages!

[Dreamcast18]

Created a new thread for it.

http://www.prowltalk.com/forum/viewtopic.php?p=8258#8258

On a similar/different subject, I need to replace the oil pressure sending unit/sensor.... I see NOTHING on that one. I got the part, and it's probably a direct replacement, and I "think" it's right around the filter there somewhere... :)
Didnt even see it on Norm's many helpful pages!

[halicat]

I take it you don't want the fax then Jim?

Thank you very much for the offer, but I've got a great idea where these things are now...



:tu:

Jim

[GT]

Mine was a 5minute job..hope yours goes as well too! :)

[halicat]

i'm keeping them for spares..
I don't want to get stuck in the backwoods of Newfoundland in 2nd gear.....

The mooses would get me.... :wink: